Rubicon Air Compressor?

[aw12345]

I don't like having anything "kinda" broke on my rig. I'm going to go ahead and put Currie on. She'll eventually need it anyway. I wheel a lot.

Sorry to say it, but I have bend the tierod and draglink on my Currie steering and happily straightened them.
You plkay in rocks, stuff bends, then you repair and repeat the process

[I H8RDS]

Sorry to say it, but I have bend the tierod and draglink on my Currie steering and happily straightened them.
You plkay in rocks, stuff bends, then you repair and repeat the process

Ya, I get that..but I don't need to try and bend back stock steering. I need to upgrade anyways.

[Jeeperator]

HEHE Art tends to run into rocks instead of going over them he must think its a bulldozer because its yellow lol. No time better than now to replace a weak ass bent draglink.

[I H8RDS]

I agree!

[aw12345]

HEHE Art tends to run into rocks instead of going over them he must think its a bulldozer because its yellow lol. No time better than now to replace a weak ass bent draglink.

The Tinkertoy is the bulldozer, I should paint it Cat yellow and put some Cat stickers on the hood lol and yes I bend the steering on that one too. Is why I re did it and raised it up some more for added protection.
The stock tierod is a piece of junk, the stock draglink is ok. Not as strong as a Currie one but adequate, remember it bettewr to bend the tierod or draglink than break a steering arm of the knuckle or break the pitman arm. The steering needs a bit of give as long as it does not collapse like the stock tierod