Steering cooler

[Jeep Virgin]

Has anybody installed a power steering cooler on a TJ ? I ahve a 06 Rubi and have a spare small trans cooler and was gonna try to use it for a steering cooler. I take it that one line is low pressure and one is high pressure, so i could intall it on the low pressure side, it would triple my capacity which would proablly help alot.
Any ideas would help me
thanks

[xjkevin]

cooler

I ran the return line-low pressure- from the steering box into the cooler and then another line from the cooler to the pump, did that make sense ive been sick and cant think very well, make sure you use tranny rated hose, and on mine-not a rubicon there was a hard line on the pump that had to be bent or you cant get the hose on, if so use a little bender, that sucker breaks and its new pump time, hope this helps a bit Stuart////

[blkTJ]

should be just as you thought. install it on the low pressure return to the t/c pump resevoir. TJ resevoirs had a plastic barbed fitting that the hose attached to, be careful not to break it. you'll need a couple feet of 3/8 low pressure steering hose if you want to put it in front of the radiator. I zip tied mine to the "V" bracket inside the grill.

good luck.

[Bachman]

Yep, just like Brian said!:yay: Works great!

[aston]

I'm curious, what is the problem you are trying to solve? Apart from hot ps fluid :homer:

[Jeep Virgin]

I'm curious, what is the problem you are trying to solve? Apart from hot ps fluid :homer:

On some of the more technical trails my power steering fluid gets real hot and boils over causing the pump to whine. Just trying to keep it cooler, and the cooler would probally triple the amount of fluid there.

[blkTJ]

I'm curious, what is the problem you are trying to solve? Apart from hot ps fluid :homer:

hot or boiling power steering fluid leads to steering fade (no or very difficult steering).

I REALLY like the new nanna. :yay:

[poultry411]

is there a common aftermarket cooler, like a b&m trans cooler that could be used? how much pressure you figure the low end of the pump has? Does the lines work if you use std. hose clamps or is there a prefered method here?

[blkTJ]

is there a common aftermarket cooler, like a b&m trans cooler that could be used? how much pressure you figure the low end of the pump has? Does the lines work if you use std. hose clamps or is there a prefered method here?

both Rick and I use the same B&M stacked plate trans cooler, just pick one that fits where you want to put it.

no idea, i think low pressure steering hose is rate at about 300 psi.

hose clamps or push lock hose and fittings are fine.

[RAT]

both Rick and I use the same B&M stacked plate trans cooler, just pick one that fits where you want to put it.

no idea, i think low pressure steering hose is rate at about 300 psi.

hose clamps or push lock hose and fittings are fine.

Here are some links to different types and manufactures of steering coolers. The DANA site has a PDF with some good info.
Rat




http://www.derale.com/power-steering-coolers.html

http://www.howeperformance.com/accessories-coolers.htm

http://www.dana.com/Automotive_Syste...platepsoc.aspx

[poultry411]

that's what I call a cheap YJ trick. Thanks, I'll put it on the list of future mods.