No announcement yet.

New here!


Forum Thread First Post

  • Filter
  • Time
  • Show
Clear All
new posts

  • New here!

    I've been on this site for a long time but have never registered. Usually browse around. Someone from MJR used to stop by our forums every now and again but I havent seen him on there in a while. Nice to see more local wheelers around.

    - Tony
    Last edited by RoCkSkuLLz; 03-21-06, 01:27 PM.
    90 YJ, 40" MTR's, 102 WB, 5.13's, 4.1, & stuff

  • #2 pics of your YJ with the 40" tires...:thumbs_up
    '98 Black TJ [COLOR=Blue]Sport[/COLOR] 4.0L/Auto Trans

    My rig :


    • #3
      Its been changed a little since these pics but here.

      Vehicle Spec's:

      Model / Year: 1990 Jeep Wrangler
      Engine: Golen Engine 4.6L Stroker, 68mm throttle body, 24lb. Cobra Mustang Injectors, Borla header, 3" exhaust from header back - Flowmaster super 40 series muff, hi flow cat. 270 hp. / 300ft./lbs of torque, 3-core radiator. DirectHits performance ignition system with Screamin Demon coil and distributor, 3" intake w/Green Filter cone filter.

      Transmission: 2000 TJ 32RH 3-speed automatic TJ console and 3-speed shifter, B&M transmission cooler, Deep oil pan

      Transfercase: Np-231 rebuilt with JB conversions kit, Tera Low 4:1 low range, AA 32 spline H.D. slip yoke eliminator kit with Tom woods long spline heavy-duty driveshafts, Indexing ring clocks the t-case flat. (front shaft has 26" of travel)

      Front axle: Dana 44, full floating with hubs, 30 spline Warn alloy shafts, CTM U-Joints, 5.13 gears and a Yukon full spool. Shaker Hi-Steer arms, 3/4" Heim Joint steering

      Rear axle: Ford 8.8, 31 spline axles, Detroit full locker, 5.13 gears, disc brakes, Cast girdle diff. cover, and RoCk SkuLLz Tubed Truss

      Lift: 2.5" lifted custom Alcan springs, Spring over conversion.

      Tires: 40" goodyear MTR Rock Spiders

      Wheels: 17x9 Allied "Monster" Aluminum 32 bolt Beadlock wheels

      Steering: Custom hi-steering, Shaker hi-steer arms, custom built 1.50" with 3/4" heim joint draglink made by Mountain Offroad (M.O.R.E.) Hydraulic assist from West Texas Offroad. (2x8 Hydraulic Ram)

      Suspension: Custom Alcan leafs with offset pins - Snail wrapped for SOA - Shocks: Fox 2.0, 7/8" shaft - 14" travels with res.

      Misc Modifications: Boatside 45 degree rocker panels, Ramsey 9500lb. Patriot Platinum winch, Tomken winch plate, Thomas 1/3hp 100% cycle duty onboard air, P-10 powertank, undercarriage lighting (rock-lights), Readywelder, Mobi-Arc welder, 4" LED flush mounted tail-lights, borgeson steering shaft, Electronic idle speed controller, herculined tub, Midland digital CB, Shaker Arms with M.O.R.E Custom 1.5" sleaved chromoly draglink. West Texas Offroad Hydraulic assisted steering (2x8 Hydraulic cylinder), 15 gal.aluminum RCI Fuel Cell in Tub, CTM U-Joints, Warn alloy shafts (inner & outers) Custom RoCk SkuLLz full roll-cage, Mico E-brake lever locking system (not installed yet), All Pro Off-road Rock-Crawler Hood, PRP Racing Seats, Extended wheelbase to 102", Poison Spyder Custom Corners, Totally flat t-case skid plate.

      Future Mod's: Atlas II, Making it more street legal (Cop Friendly)

      90 YJ, 40" MTR's, 102 WB, 5.13's, 4.1, & stuff


      • #4
        Very nice! :thumbs_up :thumbs_up
        '98 Black TJ [COLOR=Blue]Sport[/COLOR] 4.0L/Auto Trans

        My rig :


        • #5
          Nice rig...good people here at MJR...Welcome
          1997 TJ hp44/hp60-a lot of goodies


          • #6
            Nice jeep. Looks nice with those 40's.


            • #7
              Sweet rig!

              1996 Jeep Cherokee Sport
              3" Rough Country Lift


              • #8
                nice rig! and welcome.
                Not In The Office Look For Me on The Trail's!
                It's a "Jeep Thing" you just wouldn't understand ....


                • #9
                  VERY nice rig, welcome to the group!
                  :gun: My garage ain't cluttered, it's just cozy with crap.


                  • #10
                    Welcome to the forum. I fly up to Mountains Community Hospital occasionally to pick up patients. Good whellin up there. Really like Dishpan Springs. Have to go some time.


                    • #11
                      nice rig

                      welcome to the group from the rep of the state of new mexico.


                      • #12
                        Nice rig man. Been on your site a few times. Good site. We are up there all the time we will have to hook up for a ride soon.
                        97 TJ, 4" ProComp, 1" BL & MML, RE Adj. Control Arms, Rear 44 ARB. Front ARB. 35" MT/R's, York OBA
                        Rock-it Man gear, STaK 3 Sp.