I have a SwayLoc system from Offroad Only. I broke it somehow. The pear shaped part sheared right off. I have a new one, but I am having a heck of a time getting the crosslink bar off the splined shaft its attached too. I removed all the bolts and pulled, pushed, tweaked, wiggled and kicked at it without success. I even tried crowbars and a 5lbs sledge, but it was not budging. So how do I pull these pieces off the spline? Anyone have any ideas?
Here is the new part:
Here is the splined teeth on the new part. The parts that need to be removed are similar:
It goes behind this assembly. The long bar that parallels the frame is the part that needs to come off near the front bolt.
Here is a shot from directly below, looking up at the assembly:
Here is the new part:
Here is the splined teeth on the new part. The parts that need to be removed are similar:
It goes behind this assembly. The long bar that parallels the frame is the part that needs to come off near the front bolt.
Here is a shot from directly below, looking up at the assembly:
Comment