Tweet
When replacing the 4x4 vaccuum lines with new ones, do I have to do it any certain way or can I just disconnect and reconnect?
-
Yellow 01 Sport
4" Pro Comp lift | D44 | 33x12.5 Duratracs -
just do one at a time so they get back to the same routeingcensored for having an opinion -
Ok... I wasnt sure if they would have any pressure or anything in them... Thanks.Yellow 01 Sport
4" Pro Comp lift | D44 | 33x12.5 DuratracsComment
-
well different ones do different things, and use different preasuresOriginally posted by crawlin92
so if you get them mixed up, things will be opening at the wrong time or have the wrong preasure on them
one at a time and good luckcensored for having an opinionComment
-
Black ZZR has a good point. One at a time and you will be fine. Note: Make the new vacuum lines a little long so the wont pull off and you can trim the ends if they get hard, keep them away from heat sources and if you tie strap them up, don't cinch the straps to tight as to crimp the lines. Here is a site for usefull information if you get stuck.
http://home.sprynet.com/~dale02/list.htmComment
Comment