Okay starting this as a new thread to get attention. I am have major problems mounting the tires.
Here is what I am doing.
I lay the tire down on the ground so the white letter is facing up. I want the white letter on the back of the tire.
I spray the bed facing up with some simple green.
I slide the rim FACE down into the tire at an angle. By face I mean the side with the bead lock ring, the outer locker ring is off.
I try beating the chit out of the rim with a dead blow hammer. The bead never pops in.
So where am I going wrong?
I'll check back in a little bit. If you want, PM me a number where I can call.
Thanks
Here is what I am doing.
I lay the tire down on the ground so the white letter is facing up. I want the white letter on the back of the tire.
I spray the bed facing up with some simple green.
I slide the rim FACE down into the tire at an angle. By face I mean the side with the bead lock ring, the outer locker ring is off.
I try beating the chit out of the rim with a dead blow hammer. The bead never pops in.
So where am I going wrong?
I'll check back in a little bit. If you want, PM me a number where I can call.
Thanks
Comment