Going to wiring the jeep for flat tow. Question?

[Guest]

I am going to put the 7pin adapter in the front. Not 100% where. Either the front lower grill or the side of the hood.

Question? Is there a place to access the wires in the front for the tail, turn, and brake lights? Some place under the hood I can "tap into"?

Thanks

[curtis]

I ran my wires all the way to the tails lights inside the frame.

[Guest]

Thanks Curtis,

There is a hole in the begining and the end of the frame?

[OU812]

This is my plan. The wires that are in the drivers kick panel are tail light wiring. You can tap into them but must use diodes. Its a simple setup. Here is the writeup.
http://www.jedi.com/obiwan/jeep/flattow.html

[Guest]

That's the way in the end I ran it

Here is a pic on the outside adapter for "plug-in play".

[Warren]

This is my plan. The wires that are in the drivers kick panel are tail light wiring. You can tap into them but must use diodes. Its a simple setup. Here is the writeup.
http://www.jedi.com/obiwan/jeep/flattow.html

This is what I did - Mounted the plug right to the bottom of the bumper.

[Guest]

Completed.

The wire diagram shown didn't match my 1993 Wrangler. I purchased a test light at HF for $3 and figured it out. If anyone needs help, just post. I can get you the color wire(s) needed.

[OU812]

Did you used diodes or just tap into the wires?

[Guest]

Diodes from RV place. I did both brake lights. Not the tail nor the reverse light (I know, I hooked it up anyways..haha). I bought the 5 wire (pre-wire) from home depot for $.32 a foot. Few tip tires and plastic conduit for the engine bay and she is done. I tested it with a hot wire from battery up front to assure it works since I don't have the coil wire (suburban to jeep) yet (dang online stores).

Any questions, just ask!