Well I was under the jeep changing out the rear seal on my T-case and was looking at the rest of the underside while i was down there.
The bolts that hold the t-case/trans mount to the adapter piece are gone. The mount is secured to the skidplate but not to the t-case/trans adpater piece.
I am not sure what bolt size fits in there. Tried 3/8nc bolts, but they were loose in the hole. Tried 10mm(fine) and they were slightly loose in the hole. Anything larger than 3/8 or 10mm wont start in the threads.
If anyone has a t-case adapter laying around and could check the size for me.
I think I am going to have to drill them out and heli-coil the adapter but want to be sure before i tear it all apart to do it. Can't see the threads themselves yet because it was getting late/dark and I haven't pulled the t-case skid off yet.
Thanks in advance.
The bolts that hold the t-case/trans mount to the adapter piece are gone. The mount is secured to the skidplate but not to the t-case/trans adpater piece.
I am not sure what bolt size fits in there. Tried 3/8nc bolts, but they were loose in the hole. Tried 10mm(fine) and they were slightly loose in the hole. Anything larger than 3/8 or 10mm wont start in the threads.
If anyone has a t-case adapter laying around and could check the size for me.
I think I am going to have to drill them out and heli-coil the adapter but want to be sure before i tear it all apart to do it. Can't see the threads themselves yet because it was getting late/dark and I haven't pulled the t-case skid off yet.
Thanks in advance.
Comment