CJ Brake upgrade YJ booster

[Davisrats]

OK, I have a CJ, with an early YJ booster and late YJ tub.

What four wheel disk brake master cylinder will work with this setup and hopefully have the brake lines come out the drivers side.

R

[Davisrats]

Anyone?

[TDS SD]

Disc Brakes

I have disc brakes F/R. Front on my 44 are from a 70-76 K10. Rear are from a 98 Ford Explorer. My Master Cylinder is from a early Corvett with 4 wheel disc brakes. I believe 82-84. Don't have part numbers. Hope that helps.
George

[Davisrats]

did you uses a new combination/proportioning valve?
I also have explorer disks in the back and ford disk-chevy caliper mix up front.

Thanks

[TDS SD]

Brakes

did you uses a new combination/proportioning valve?
I also have explorer disks in the back and ford disk-chevy caliper mix up front.

Thanks

You have about the same setup as I have. I'm not sure about the proportioning valve. If you need the part # for the master Cyl I can hunt it down.

[Davisrats]

please let me know the number you used.

Thanks
Ron

[TDS SD]

Brakes

please let me know the number you used.

Thanks
Ron

Called MIT today (They Installed MY Setup) They didnt have a part number but the Mastercylinder comes from an 82 Corvette with power booster. The power booster matches the vehicle it is going on. The proportioning valve is disbaled. MIT in El Cajon or VanCo in the LA area are good sources. I got my replacement when my Master Cyl. went out from NAPA. They looked up by vehicle 82 Corvette and got one from the shelve.
It was so long ago I no longer have the paper work. Hope that helps.
George

[Davisrats]

has anyone seen a yj master cylinder for 4 wheel disk, that has the lines come off the drivers side?

[TDS SD]

Brake Lines

has anyone seen a yj master cylinder for 4 wheel disk, that has the lines come off the drivers side?

I'll Take a picture in the AM.
George

[Davisrats]

I'll Take a picture in the AM.
George

That would be cool.

Do you have a part number? manufacturer?

Thanks again.

Ron

[TDS SD]

Master Cyl

All I know is the donor was an 82 Corvett with four wheel disc brakes.
http://www.myjeeprocks.com/forums/ga...akSetup001.jpg
http://www.myjeeprocks.com/forums/ga...akSetup002.jpg
I also used an external slave cyl from an 80 CJ5. (Advance Adapters)

[Davisrats]

Cool, thanks.
I went on autozone.com and they only show one M/C for an '82 Vette.

[TDS SD]

Master Cyl

Cool, thanks.
I went on autozone.com and they only show one M/C for an '82 Vette.

When I had to replace mine because it developed an internal leak I went to Napa with the info I gave you and they went through their books. Of course I had the sample in my hands. Maybe the photo and info will be enough.
Napa Has one listed
http://www.napaonline.com/masterpage...cription=Brake Master Cylinder - New
George

[Davisrats]

Thanks

[Davisrats]

Well the 82 vette master does not fit my booster. I have an older style (1990), maybe that is the difference. The bolts holes are off slightly, but the push rod is off by about an inch.
I looked on autozone.com and the 1990&1993 yj have the same master cyclinder. Hmmmm