96 jeep xj

[switchhappy]

i just had a aliment done on my xj after a lift and new tires. when i got it back out of the shop it now drifts to the right and the steering wheel shakes a lil only at about 50 to 55 mph.. any faster its fine any slower its fine.. what are the specks for a jeeps front end.. i thaink they aligned it got a zj cus the sheet sayes zj, so my ? is does the zj have different specks then the xj
my curent mesurements are
camber -0.7 -0.3
caster -6.7 -6.9
toe 1/16 1/16

[xjkevin]

the specs should be the same,

[2BlUeJEEP]

I had that exact problem with my WJ.. I'm not sure what it is but now it is starting to have some issues in the front end I'm not sure if its out of alignment again or wheel bearing, ball joint or so on... My left front tire is leaning in heavy on the top side... So if you figure it out before I do let me know and I'll do the same thanks

[RUGD JP]

Tires balanced ? You check your wheel bearings ? Jack up both sides, one at a time, grab the tire from the top and bottom and and push in and out; if the tire has play your wheel bearings are toast. How high did you go and what size tires ? Could possible be your track bar, do you still have your stock one ? Do you have a SYE ? you sure its not driveshaft vibes ?

[switchhappy]

well i took it back to the people who alined it, they twicked it and done a few other stuuf and now its fine.. they messed up when they did it the first time, they just dident wanna tell me.. and i went up 4.5 on the lift with 31 bfg, at, tires.. the only vibs i got it the front drive shaft.. if i take it out it is fine, its not loos its just got a bad pion angle.. how can i clear that up, adj uppers..?