Announcement

Collapse
No announcement yet.

3.5" re with 1" bl and 35's

Collapse

Forum Thread First Post

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3.5" re with 1" bl and 35's

    Anyone have any pics of this setup? I'm thinking of going to 35's and am wondering if I'd rub bad and how it would look. TIA

  • #2
    JP magazine said it could be done with a TeraFlex 3.5" and 1" BL with minimal rub. RE's are supposed to set a bit higher (to begin with at least). 1" BL is minimally noticeable but may req dropping the radiator fan shroud.

    To imagine your Jeep with that combo click below
    http://ptheune.net/~pir/photos/Jeeps...ctor/index.htm
    Quis custodiet ipsos custodes?
    2003 TJ Rubicon: 4.5" OME coils; RE SF2; NthDegree TT/oilpan skid/shock shifters; FXD rock rails; Anti-Rock; 5150'

    Comment


    • #3
      I'm not worried about the rad. shroud. I already have the 3.5re and the bl installed. I was just wondering how much room I'd have in the wells if I went to 35's.

      Comment


      • #4
        This is with a 4.5re and 1"BL...I guess you can visualize it an inch shorty to figure out clearances. Hope this helps a little.



        edit: with 33's
        04 Rubicon
        4.5" RE Super Flex
        1" BL
        CV Yoke w/ Driveshaft
        Currie Anti-rock swaybar
        35" el cheapos
        Front Bumper & Rockers

        Comment


        • #5
          With bumpstop extensions and properly backspaced wheels you won't rub at all.

          Comment


          • #6
            Thanks for the info all.

            Comment

            Working...
            X