alignment issues!!

[monkeywrenchy]

Ive noticed my 04 Rubicon pulling to the left hard at low speeds after a coyote canyon trip, have had two alignment shops say nothin wrong!!??? Checked everything and found no apparent bends or loose ends! Any ideas, or really good shops in San Diego?

[Schmo]

Ive noticed my 04 Rubicon pulling to the left hard at low speeds after a coyote canyon trip, have had two alignment shops say nothin wrong!!??? Checked everything and found no apparent bends or loose ends! Any ideas, or really good shops in San Diego?

When I got mine aligned recently, they provided a sheet listing all the different specs. Did you get something like this when you got it done?

[FRMNJJ]

if you are running the stock MTR's, check for abnormal wear which they are known for, brakes pads and rotors. Bent tie rod or something else in the steering system, or worn out control arm bushings.....just a few things off the top of my head....sure someone else will bring some other things to check

[monkeywrenchy]

I got a breakdown sheet that reads Greek to me!!
Ive got new tires,Ive swapped tires, new rotors and pads......I do have a stock front end parts gettin hard use by my 35s...maybe its time to upgrade?
I have noticed a small "knock-knock" sound on front left sometimes though on braking...hmmmm

[FRMNJJ]

hmmmmm....roll underneath it and make sure EVERYTHING is tight.....check the tie rod ends too

[Shadly1]

I got a breakdown sheet that reads Greek to me!!

Are they all in spec and near equal on each side? Can you post them or scan the spec sheet or something?

[Jerry Bransford]

Take it to a 4x4 shop that has an alignment rack, few regular alignment shops know anything about Jeeps. Where in San Diego are you located? ORW is pretty good with things like that.

[97sahara]

does it pull to the right when u brake? it could be a locked up caliper on the left side