Under the knife again

[NAILER341]

they will indeed be changing.
there is only 2" of shock left in there
we'll see where it winds up after the cage goes in, and get some new springs.

I expect the jeep has lost well over 500#.

[aw12345]

What material was used for the bellyskid?
I like that flat belly skid a lot looks like 1/2 inch aluminum 6160t6 plate, am I correct in that? Also does it have any cross bracing?

[seapahn]

It's so purdy as it is!!!! It's going to need a trail rated sticker.

[NAILER341]

What material was used for the bellyskid?
I like that flat belly skid a lot looks like 1/2 inch aluminum 6160t6 plate, am I correct in that? Also does it have any cross bracing?

the skid is 6061 t6 @ 3/8" with the trans support as bracing.
The oil pan skid is 7075 @ 3/16" with no central support.

[NAILER341]

It's so purdy as it is!!!! It's going to need a trail rated sticker.

It does need the Trail Rated" emblem. Do you have an extra?

[seapahn]

I'll try to find one. I need one for mine too.

[aw12345]

Thanks Eric

[Dezertdog]

Wow Erik,
That Jeep is lookin SWEET!

Keep it up.

Scott

[provelogear]

Erik's Jeep is really coming along nicely! Chris and Blaine have most of the cage done.

[miguelitojeep97]

looks good, is that rear fender going to clear the tire, or will it be trimmed later on?

[mrblaine]

looks good, is that rear fender going to clear the tire, or will it be trimmed later on?

We're going to let it self clearance.

[miguelitojeep97]

We're going to let it self clearance.

ha ha very funny

I just assumed you would trim before painting, but what do I know, I'm just a dumb college student. I'll go with answer b) Gen Right aluminum full corner gaurds

-mike

[provelogear]

ha ha very funny

I just assumed you would trim before painting, but what do I know, I'm just a dumb college student. I'll go with answer b) Gen Right aluminum full corner gaurds

-mike

LOL! Savvy Full Corner Blanks for the YJ!

[mrblaine]

ha ha very funny

I just assumed you would trim before painting, but what do I know, I'm just a dumb college student. I'll go with answer b) Gen Right aluminum full corner gaurds

-mike

Why would I use Genright corners when I have a pair of the YJ blanks that we make?

If I followed your logic, then I would also need to send it out to paint after I drill all the mounting holes to hang the corners and rockers.

[KINGSIZE]

Looks good so far Erik.