Announcement

Collapse
No announcement yet.

AMC 360 in 89 xj

Collapse

Forum Thread First Post

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • AMC 360 in 89 xj

    i need to know all the things i need to about bolting in a AMC 360. motor mounts, cooling system, and anything else i might need to know before i start on this project? thanks

  • #2
    Call Advance Adapters at (805)238-7000, and ask them for their engine and transmission conversion kits manual. There is way too much information for you to need to know to try to relay it all in a forum...

    Comment


    • #3
      What tranny are you mating that beast to? Don't forget to get a bigger clutch if you are running a Jeep tranny. I'd get an 11" setup... You will probably find out the hard way that a 10 1/2" (esp a stock clutch) is not sufficient.
      1986 CJ-7; 4.6L stroker, balanced & blueprinted; 5" lift, 35x1250 MTRs, Poison Spyder Full Width kit,
      My Jeep

      Moab Rocker Knocker Video:shades:

      Comment


      • #4
        i am using a t18 tranny with a dana 20 transfer case. do you know anything about the engine,tranny, and transfer case mounts? thanks
        Last edited by crayzeemud; 11-24-03, 08:32 AM.

        Comment

        Working...
        X