Lowering suspension on Comanche

[assyrianjeep]

im talking about struts as in a sway bar, i missed used the wording, a sway bar in the front and rear

[Dukes69]

How much money do you have to spend?

I doubt there is a company that makes lower springs. I would suggest contacting a custom spring company such as deaver or national. That would be for the front and rear. Unless you just want to throw some blocks in the rear and call it good, which is a lame ass way out. If you want to get really fancy, air bag the thing. Ditch the leafs in the rear and build a 4 link.

I dont know what the other dude is talking about with struts? Maybe he's confused them with coil overs?

[moparforever]

are you saying i should upgrade the struts and springs on the front? for the back.....do what, i dont understand, bc it already has leaves?

[assyrianjeep]

if you wanna lower it just dont.. its really to much work, just get some nice leafs and put struts on the front and rear, you should handle in the PAVED canyon pretty well you would be surpise how much body roll is resistant when you add struts.

[moparforever]

it came 2wd, thats what it did to me, and it came nice and light, and with a potential-filled I6

[Rudeboyrob88]

Please don't lower your Jeep, what did it do to you?

[WheelingPiazza]

I say if your going to go through the hassels of lowering it, just airbag the whole damn thing.

[king4wd]

Lowering a Jeep is just plain wrong. Leave the suspension as is, or possibly go to Bilstien springs (1" lift, but substantially stiffer), and get stiffer aftermarket swaybars (like Addco). This will help your handling more than lowering it, as it would better control bodyroll while keeping all 4 wheels on the ground (you see lowered trucks bouncing and hopping all the time). Second, go with street tires over light truck tires. Mind you, although they will handle better, your payload capacity will drop but not as much as it would if you had slammed the rear. Godd luck with your project. I'd be interested in seeing the results.

[Jeri Lyn]

If you really want to break your truck then go ahead and start cutting springs. I have a nice vid of my buddy tearing his entire exhaust and front end after we sawzawed his springs and he hit a small dip. it was magnificent.

Going that route is very craptacular. You'd be better off saving up and buying the lower springs. my :2:

[Kaffa]

If you really want to break your truck then go ahead and start cutting springs. I have a nice vid of my buddy tearing his entire exhaust and front end after we sawzawed his springs and he hit a small dip. it was magnificent.

[rick]

LOL, nice Ted. An SRT-10 will do it.

To fine tune the rear height you can remove the second leaf down (from the top main leaf) from the springs, but this will also change the spring rate and make it bottom much easier. I'm assuming you won't be hauling anything...

[jmbrowning]

snip or heat coil to get front end down.

I doubt that lowering your OEM truck will improve its street handling any. I'd recommend trading it in for a street-oriented truck like the SRT-10.

[moparforever]

I have an 88 comanche and would like to make it into a street truck. I would like to lower it so it would handle better. Here is my question. What is the best way to go about lowering it? I assume i will have to fabricate everything because i doubt there is a lowering kit for a jeep. Or is there? For the rear, which is leaf springs, i can use lowering blocks by putting them between the leaves and the axle, which is on the tops. This still leaves the front suspension which is coils. Any help is appreciated