NP242 Transfercase

[8wr_ZJ]

here is some information i found while looking into what t-case i need to replace my 249.
http://www.duff.ws/grand_central/tc_swap/249_vs_242.htm

http://www.high-impact.net/transmiss...case_NP231.htm

I hope this helps you figure out what to do! Good luck!

[Dukes69]

I dont see why you couldnt. You will just loose the full ttime function. IIRC different years/engins have different spline counts/imput shaft lengths. Just count and measure yours so you get the right one. Try E-bay for one?

[loudjeep90]

by the way, the trans is a Aw4 auto..

[loudjeep90]

Hey Folks, I have been registered here for a while but i havent had much free time, but now i have a pretty big problem and i need some advice.

the NP242 on my jeep grenaded today out on the highway, and i called some local junkyards, and none of them have a 242. My question is, can I install a 231 or some other T-Case in its place. And also, what alse should i check for damage, i was goin about 70 and the T-case blew apart, just wondering if this could have hurt anything else. Thanks alot